Impact-Site-Verification: 9a9b300a-4531-4d09-948d-7d6fb53f5a3fImpact-Site-Verification: b1a0f7f7-4af8-4172-9f19-79c724a60e86
PoolGearGuide

How to Winterize an Above-Ground Pool, Step by Step

By Luke Ferguson · Research-based · Updated 2026-10-21

How to Winterize an Above-Ground Pool, Step by Step
Share

Winterizing an above-ground pool comes down to seven steps: balance the water, add winter chemicals and shock, clean and lower the water level, drain and store the equipment, protect the walls with an air pillow, cover the pool, and check on it through winter. Do these in order and your pool should open clear in spring instead of green.

Closing a pool is not about making it perfect. It is about parking the water in a stable, balanced state so nothing grows, freezes, or stains while the cover is on.

When should I start winterizing?

Wait until the water stays below about 60 degrees F. Algae and bacteria slow way down in cold water, so a pool closed cold and balanced holds much better than one closed while it is still warm.

In most of the country that means mid to late fall. If you close too early, you are basically sealing warm water under a cover for weeks, which is how green surprises happen. Watch the water temperature, not the calendar.

Step 1: Balance the water first

Test and adjust your water a few days before you close, not the same afternoon. Balanced water going into winter protects the liner and metal parts from scaling and corrosion. If chemistry still feels like a foreign language, our pool chemistry basics guide walks through each number.

Aim for these ranges before closing:

The CDC's guidance on home pool water treatment is a good plain-language backstop for why these ranges matter for safe, clear water. Balanced now means less corrosion and staining come spring.

Step 2: Shock the pool and add winter chemicals

The day you close, shock the water to knock out anything living in it. A cal-hypo (calcium hypochlorite) shock like HTH Super Shock Treatment (Cal-Hypo, 1 lb bags) raises chlorine fast. Run the pump for several hours after adding it so it mixes fully.

Let the chlorine drop back toward normal (below about 3 ppm) before you add anything else, because high chlorine can burn off algaecide and clarifier. Then add a long-lasting winter algaecide such as In The Swim Algaecide 60 Plus (1 Quart) to hold back growth for the months the cover is on.

Handle every chemical one at a time and never mix concentrates in the same bucket. The EPA's chemical safety alert and NPIC's pool chemicals factsheet both stress storing products dry, separated, and in original containers. That matters most in fall, when everything gets stacked in a shed together.

Step 3: Clean the pool and lower the water

Brush the walls, vacuum the floor, and empty the skimmer and pump baskets. Anything organic left in the water, leaves, dirt, bugs, becomes algae food under the cover.

Then lower the water level. For a solid winter cover, drop it about 4 to 6 inches below the skimmer and return fittings so water is not sitting in lines that can freeze. If you use a skimmer cover plate or a special mesh cover, follow that product's instructions instead, since some keep the water higher.

Do not drain the pool all the way. The water is what braces the walls and keeps the liner from shrinking. An empty above-ground pool is a pool that can buckle.

Step 4: Drain and store the equipment

In any climate that freezes, water left in the pump, filter, hoses, or chlorinator will expand and crack the housing. That is the single most common expensive closing mistake.

Do this:

  • Remove the drain plugs from the pump and filter and let everything drip dry. Toss the plugs in the pump basket so you find them in April.
  • Disconnect and drain the hoses.
  • For a cartridge filter, rinse the cartridge and store it dry. For sand or D.E., follow the manual for the winter drain position.
  • Store the pump, plugs, and any electronics somewhere dry, not on a wet shed floor.

If you run a saltwater system, drain and store the salt cell too, and check its manual for winter care. Our saltwater pool maintenance guide covers cell handling in more detail.

Step 5: Add an air pillow and cover the pool

An air pillow floated in the center does real work. As surface ice forms and expands, it pushes inward on the pillow instead of straight out against your walls. Inflate it about halfway so it has room to compress.

Pull your winter cover over the pool and secure it with the cable and winch or cover clips so wind cannot lift it. A snug cover keeps out leaves, sunlight, and critters. Standing water and debris on top can be pumped or siphoned off through the season, and a cover pump makes that easy.

You can find covers, air pillows, plugs, and closing chemicals on our pool maintenance supplies page if you are restocking before the cold hits.

Step 6: Check on it through winter

Winterizing is not fully hands-off. Pump standing water off the cover after storms so the weight does not stretch or sink it. Clear heavy leaf piles and snow load when you safely can.

On a mid-winter thaw, take a quick look under the cover if you can. Water that has gone cloudy or off-color may need a small dose of chlorine on the next warm-ish day. Catching it in January is far easier than opening to a swamp in May.

The short version

Balance, shock, clean, lower, drain, cover, and check. That order keeps your water stable and your equipment intact while nothing is running.

If you also close a spa or hot tub for the season, the same drain-and-protect logic applies, and our hot tub maintenance guide covers that side. When in doubt, check the product manuals, since the exact water level and drain steps depend on what you own.

Frequently asked questions

When should I winterize my above-ground pool?

Close it once the water stays consistently below about 60 degrees F, usually mid to late fall depending on your region. Colder water slows algae growth, so a cover added to cold, balanced water stays cleaner. Closing too early while the water is still warm invites algae under the cover.

Do I have to drain my above-ground pool for winter?

No, and you usually should not fully drain it. Lower the level below the skimmer and returns (about 4 to 6 inches, or per your cover type), but leaving most of the water in supports the walls and liner. A fully empty above-ground pool can shift, collapse, or let the liner shrink and crack.

Can I leave my pump and filter outside over winter?

In freezing climates, drain the pump, filter, hoses, and any chlorinator completely and store them somewhere dry, since trapped water expands and cracks housings. Remove drain plugs and keep them in the pump basket so you can find them in spring. In frost-free areas you may be able to keep running the equipment instead of closing, but check your equipment manual.

How much does it cost to winterize an above-ground pool?

A DIY winter chemical kit plus a cover for a typical above-ground pool often runs from around a cover-plus-chemicals budget you can price from current listings, and it varies with pool size and what you already own. The cover is usually the biggest single cost. Reusing a cover in good shape from last year keeps it cheap.

Should I add antifreeze to an above-ground pool?

Standard above-ground closings usually do not need pool antifreeze in the pool itself, since you lower the water and drain the equipment. Never use automotive antifreeze anywhere near a pool, as it is toxic. If you have rigid plumbing that cannot fully drain, use only non-toxic pool-rated antifreeze and follow the label.

Written by

Luke Ferguson · Founder & Editor

Research-driven pool reviews — spec sheets, warranties, and thousands of owner reports, in plain English. More about Luke →

The weekly skim

One short email a week: what to test, what to buy, and what to skip. No daily drip. Unsubscribe anytime.

Keep reading